Cisco AP775A - Nexus Converged Network Switch 5010

Send comments to nx5000-docfeedback@cisco.com
8-72
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fcsp enable
fcsp enable
To enable the Fibre Channel Security Protocol (FC-SP) in a switch, use the fcsp enable command.
Additional FC-SP commands are available when the FC-SP feature is enabled. To disable FC-SP, use the
no form of the command.
fcsp enable
no fcsp enable
Syntax Descriptionf
Command Default Disabled.
Command Modes Configuration mode
Command History
Examples The following example enables FC-SP:
switch(config)# fcsp enable
Related Commands
fcsp Specifies the FC-SP feature in the switch.
enable Enables the FC-SP feature in this switch.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show fcsp Displays configured FC-SP information.