Send comments to nx5000-docfeedback@cisco.com
2-6
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
cdp enable
cdp enable
To enable the Cisco Discovery Protocol (CDP) on an Ethernet interface, use the cdp enable command.
To disable CDP on the interface, use the no form of this command.
cdp enable
no cdp enable
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Interface configuration mode
Command History
Examples This example shows how to enable CDP on an Ethernet interface:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# cdp enable
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show interface Displays the interface configuration information.
To Next Page
Loading...
