Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-52
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fcdomain rcf-reject
fcdomain rcf-reject
To enable the RCF reject flag for a Fibre Channel interface, use the fcdomain option. To disable this
feature, use the no form of the command.
fcdomain rcf-reject vsan vsan-id
no fcdomain rcf-reject vsan vsan-id
Syntax Description
Command Default Enabled.
Command Modes Interface configuration mode
Command History
Usage Guidelines Use this option to configure the RCF reject option for the selected Fibre Channel or virtual Fibre Channel
interface.
Examples The following example shows how to configure the FCIP RCF reject fcdomain feature on a virtual Fibre
Channel interface:
switch(config)# interface vfc 3
switch(config-if)# fcdomain rcf-reject vsan 1
Related Commands
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show fcdomain Displays global information about the Fibre Channel domain configurations.
show interface fc Displays an interface configuration for a specified Fibre Channel interface.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English