Cisco AP775A - Nexus Converged Network Switch 5010 - Show Interface Private-Vlan Mapping

Send comments to nx5000-docfeedback@cisco.com
3-3
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show interface private-vlan mapping
show interface private-vlan mapping
To display information about private VLAN mapping for primary VLAN interfaces, use the show
interface private-vlan mapping command.
show interface private-vlan mapping
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines Before you can configure private VLANs, you must enable them by using the feature private-vlan
command. The commands for configuring private VLANs are not visible until you enable private
VLANs.
This command displays the mapping information between the primary and secondary VLANs that
allows both VLANs to share the VLAN interface of the primary VLAN.
Examples This example shows how to display information about primary and secondary private VLAN mapping:
switch# show interface private-vlan mapping
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
feature private-vlan Enables private VLANs.
show interface
switchport
Displays information about the ports, including those in private VLANs,
show vlan Displays summary information for all VLANs.
show vlan private-vlan Displays information for all private VLANs on the device.