Send comments to nx5000-docfeedback@cisco.com
8-117
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
port-track force-shut
port-track force-shut
To force a shutdown of a tracked port, use the port-track force-shut command. To reenable the port
tracking, use the no form of the command.
port-track force-shut
no port-track force-shut
Syntax Description This command has no other arguments or keywords.
Command Default None
Command Modes Interface configuration mode
Command History
Usage Guidelines Use the port-track force-shut command to keep the linked port down, even though the tracked port
comes back up. You must explicitly bring the port up when required using the no port-track force-shut
command.
Examples The following example shows how to force the shutdown of an interface and the interfaces that it is
tracking:
switch(config)# interface fc 2/2
switch(config-if)# no port-track force-shut
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
port-track enable Enables port tracking.
show interface fc Displays configuration and status information for a specified Fibre Channel
interface.
show interface
san-port-channel
Displays configuration and status information for a specified SAN port
channel interface.
To Next Page
Loading...
