Send comments to nx5000-docfeedback@cisco.com
7-32
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 7 System Management Commands
show logging onboard
show logging onboard
To display the onboard logging information based on the error type, use the show logging onboard
command.
show logging onboard {boot-uptime | device-version | endtime | environmental-history |
exception-log | kernel-trace | obfl-history | obfl-logs | stack-trace | starttime | status} [> file
| | type]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines The date and time arguments for the starttime and endtime keywords are entered as the date
month/day/year (mm/dd/yy), followed by a hyphen, and the time in 24-hour format in
hours:minutes:seconds (HH:MM:SS). For example:
• starttime 03/17/08-15:01:57
• endtime 03/18/08-15:04:57
The valid values for file are as follows:
boot-uptime Displays the OBFL boot and uptime information.
device-version Displays the OBFL device version information.
endtime Displays the OBFL logs until the specified end time.in the following format:
mm/dd/yy-HH:MM:SS
environmental-history Displays the OBFL environmental history.
exception-log Displays the OBFL exception log.
kernel-trace Displays the OBFL kernel trace information.
obfl-history Displays the OBFL history information.
obfl-logs Displays the OBFL technical support log information.
stack-trace Displays the OBFL kernel stack trace information.
starttime Displays the OBFL logs from the specified start time in the following
format: mm/dd/yy-HH:MM:SS
status Displays the OBFL status enable or disable.
> file (Optional) Redirects the output to a file. See the “Usage Guidelines” section
for additional information.
| type (Optional) Filters the output. See the “Usage Guidelines” section for
additional information.
Release Modification
4.0(0)N1(1a) This command was introduced.
To Next Page
Loading...
Need help?
General
