Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
6-44
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 6 Security Commands
ipv6 access-list
ipv6 access-list
To create an IPv6 access control list (ACL) or to enter IP access list configuration mode for a specific
ACL, use the ipv6 access-list command. To remove an IPv6 ACL, use the no form of this command.
ipv6 access-list access-list-name
no ipv6 access-list access-list-name
Syntax Description
Command Default No IPv6 ACLs are defined by default.
Command Modes Configuration mode
Command History
Usage Guidelines Use IPv6 ACLs to filter IPv6 traffic.
When you use the ipv6 access-list command, the switch enters IP access list configuration mode, where
you can use the IPv6 deny and permit commands to configure rules for the ACL. If the specified ACL
does not exist, the switch creates it when you enter this command.
Every IPv6 ACL has the following implicit rule as its last rule:
deny ipv6 any any
This implicit rule ensures that the switch denies unmatched IP traffic.
Examples This example shows how to enter IP access list configuration mode for an IPv6 ACL named ipv6-acl-01:
switch(config)# ipv6 access-list ipv6-acl-01
switch(config-ipv6-acl)#
Related Commands
access-list-name Name of the IPv6 ACL. Can be up to 64 characters long. Names cannot
contain a space or quotation mark.
Release Modification
4.0(1a)N1(1) This command was introduced.
Command Description
deny (IPv6) Configures a deny rule in an IPv6 ACL.
permit (IPv6) Configures a permit rule in an IPv6 ACL.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English