Send comments to nx5000-docfeedback@cisco.com
8-74
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fcsp timeout
fcsp timeout
To configure the timeout value for FC-SP message, use the fcsp timeout command. Use the no form of
the command to revert to factory defaults.
fcsp timeout timeout-period
no fcsp timeout timeout-period
Syntax Description
Command Default 30 seconds.
Command Modes Configuration mode
Command History
Usage Guidelines You can only see the fcsp timeout command if you enter the fcsp enable command.
Examples The following example configures the FCSP timeout value:
switch(config)# fcsp enable
switch(config)# fcsp timeout 60
Related Commands
timeout-period Specifies the time out period. The time ranges from 20 to 100 seconds.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
fcsp enable Enable FC-SP.
show fcsp Displays configured FC-SP information.
To Next Page
Loading...
