Cisco AP775A - Nexus Converged Network Switch 5010

Send comments to nx5000-docfeedback@cisco.com
9-35
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 9 Fibre Channel Show Commands
show npv status
show npv status
To display the N port virtualization (NPV) current status, use the show npv status command.
show npv status
Syntax Description This command has no other keywords or arguments.
Command Default None
Command Modes EXEC mode.
Command History
Usage Guidelines The show npv status command is available only when the switch is in NPV mode.
Examples The following example displays the current status of NPV:
switch# show npv status
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show npv flogi-table Displays the information about NPV FLOGI session.