Send comments to nx5000-docfeedback@cisco.com
3-8
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show lacp
show lacp
To display Link Aggregation Control Protocol (LACP) information, use the show lacp command.
show lacp {counters | interface ethernet slot/port | neighbor [interface port-channel number] |
port-channel [interface port-channel number] | system-identifier}
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines Use the show lacp command to troubleshoot problems related to LACP in a network.
Examples This example shows how to display the LACP system identification:
switch# show lacp system-identifier
counters Displays information about the LACP traffic statistics.
interface ethernet
slot/port
Displays LACP information for a specific interface.
neighbor [interface
port-channel number]
Displays information about the LACP neighbor. Optionally provide an
EtherChannel number.
port-channel
[interface
port-channel number]
Displays information about an EtherChannel. Optionally provide an
EtherChannel number.
system-identifier Displays the LACP system identification. It is a combination of the port
priority and the MAC address of the device
Release Modification
4.0(0)N1(1a) This command was introduced.
To Next Page
Loading...
