Send comments to nx5000-docfeedback@cisco.com
8-155
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
zone rename
zone rename
To rename a zone, use the zone rename command.
zone rename current-name new-name vsan vsan-id
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Examples The following example shows how to rename a zone:
switch# zone rename ZoneA ZoneB vsan 10
Related Commands
current-name Specifies the current fcalias name. Maximum length is 64 characters.
new-name Specifies the new fcalias name. Maximum length is 64 characters.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show zone Displays zone information.
zone name Creates and configures zones.
To Next Page
Loading...
