Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
1-58
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
modem set-string user-input
modem set-string user-input
To configure the user-input initialization string to download to a modem connected to the console port,
use the modem set-string user-input command. To revert to the default, use the no form of this
command.
modem set-string user-input string
no modem set-string
Syntax Description
Command Default None
Command Modes Terminal line configuration
Command History
Usage Guidelines You can configure the console port only from a session on the console port.
Examples This example shows how to configure the user-input initialization string for the modem connected to the
console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# modem init-string user-input ATE0Q1&D2&C1S0=3\015
This example shows how to revert to the default user-input initialization string for the modem connected
to the console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# no modem set-string
Related Commands
string User-input string. This string is alphanumeric and case sensitive, can contain
special characters, and has a maximum of 100 characters.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
line console Enters console port configuration mode.
modem init-string Downloads the user-input initialization string to a modem.
show line Displays information about the console port configuration.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English