Send comments to nx5000-docfeedback@cisco.com
2-95
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
switchport mode private-vlan promiscuous
switchport mode private-vlan promiscuous
To set the interface type to be a promiscuous port for a private VLAN, use the switchport mode
private-vlan promiscuous command.
switchport mode private-vlan promiscuous
Syntax Description This command has no keywords or arguments.
Command Default None
Command Modes Interface configuration mode
Command History
Usage Guidelines When you configure a port as a promiscuous private VLAN port and one of the following applies, the
port becomes inactive:
• The port does not have a valid private VLAN mapping configured.
• The port is a Switched Port Analyzer (SPAN) destination.
If you delete a private VLAN port mapping or if you configure a private port as a SPAN destination, the
deleted private VLAN port mapping or the private port that is configured as a SPAN destination becomes
inactive.
See the private-vlan command for more information on promiscuous ports.
Examples This example shows how to set a port to promiscuous mode for private VLANs:
switch(config-if)# switchport mode private-vlan promiscuous
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show interface
switchport
Displays information on all interfaces configured as switch ports.
To Next Page
Loading...
