Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
2-45
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
shutdown (VLAN configuration)
shutdown (VLAN configuration)
To shut down the local traffic on a VLAN, use the shutdown command. To return a VLAN to its default
operational state, use the no form of this command.
shutdown
no shutdown
Syntax Description This command has no arguments or keywords.
Command Default Not shut down.
Command Modes VLAN configuration mode
Command History
Usage Guidelines You cannot shut down, or disable, VLAN 1 or VLANs 1006 to 4094.
After you shut down a VLAN, the traffic ceases to flow on that VLAN. Access ports on that VLAN are
also brought down; trunk ports continue to carry traffic for the other VLANs allowed on that port.
However, the interface associations for the specified VLAN remain, and when you reenable, or recreate,
that specified VLAN, the switch automatically reinstates all the original ports to that VLAN.
To find out if a VLAN has been shut down internally, check the Status field in the show vlan command
output. If a VLAN is shut down internally, one of these values appears in the Status field:
• act/lshut—VLAN status is active and shut down internally.
• sus/lshut—VLAN status is suspended and shut down internally.
Note If the VLAN is suspended and shut down, you use both the no shutdown and state active commands to
return the VLAN to the active state.
Examples This example shows how to restore local traffic on VLAN 2 after you have shut down, or disabled, the
VLAN:
switch(config)# vlan 2
switch(config-vlan)# no shutdown
Release Modification
4.0(0)N1(1a) This command was introduced.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English