Cisco AP775A - Nexus Converged Network Switch 5010 - Feature Lacp

Send comments to nx5000-docfeedback@cisco.com
1-40
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
feature lacp
feature lacp
To enable Link Aggregation Control Protocol (LACP), which bundles a number of physical ports
together to form a single logical channel, use the feature lacp command. To disable LACP on the switch,
use the no form of this command.
feature lacp
no feature lacp
Syntax Description This command has no arguments or keywords.
Command Default LACP is disabled.
Command Modes Configuration mode
Command History
Usage Guidelines You must remove all the LACP configuration parameters from all EtherChannels on the switch before
you can disable LACP.
Even after you enable LACP globally, you do not have to run LACP on all EtherChannels on the switch.
You enable LACP on each channel mode using the channel-group mode command.
Examples This example shows how to enable LACP EtherChannels on the switch:
switch(config)# feature lacp
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show lacp Displays information on LACP.