Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-154
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
zone name (zone set configuration mode)
zone name (zone set configuration mode)
To configure a zone in a zone set, use the zone name command in zone set configuration mode. To delete
the zone from the zone set, use the no form of the command.
zone name zone-name
no zone name zone-name
Syntax Description
Command Default None
Command Modes Zone set configuration mode
Command History
Examples The following example configure a zone in a zone set:
switch(config)# zoneset name Sample vsan 1
switch(config-zoneset)# zone name MyZone
The following example deletes a zone from a zone set:
switch(config-zoneset)# no zone name Zone2
Related Commands
zone-name Specifies the name of the zone. Maximum length is 64 characters.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show zoneset Displays zone set information.
zone name
(configuration mode)
Configure zones.
zoneset Configures zone set attributes.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English