Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-146
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
zone commit
zone commit
To commit zoning changes to a VSAN, use the zone commit command. To negate the command, use the
no form of the command.
zone commit vsan vsan-id [force]
no zone commit vsan vsan-id [force]
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Usage Guidelines Use the no form of the zone commit command to clear a session lock on a switch where the lock
originated.
Examples The following example commits zoning changes to VSAN 200:
switch(config)# zone commit vsan 200
Related Commands
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
force (Optional) Forces the commit.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show zone Displays zone information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English