Cisco AP775A - Nexus Converged Network Switch 5010

Send comments to nx5000-docfeedback@cisco.com
8-103
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
member (zoneset configuration mode)
member (zoneset configuration mode)
To configure zone set members, use the member command in zone set configuration mode. To remove
a zone set member, use the no form of the command.
member member-name
no member member-name
Syntax Description
Command Default None
Command Modes Zone set configuration mode
Command History
Examples The following example shows how to add a member zone to a zone set:
switch(config)# zoneset name Zoneset1 vsan 10
switch(config-zoneset)# member ZoneA
Related Commands
member-name Specifies the member name. Maximum length is 64 characters.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show zone Displays zone information.
zoneset name Creates a zone set.