Cisco AP775A - Nexus Converged Network Switch 5010 - Modem Init-String

Send comments to nx5000-docfeedback@cisco.com
1-56
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
modem init-string
modem init-string
To download the initialization string to a modem connected to the console port, use the modem
init-string command. To revert to the default, use the no form of this command.
modem init-string {default | user-input}
no modem init-string
Syntax Description
Command Default The default initialization string is ATE0Q1&D2&C1S0=1\015.
Command Modes Terminal line configuration
Command History
Usage Guidelines You can configure the console port only from a session on the console port.
The default initialization string ATE0Q1&D2&C1S0=1\015 is defined as follows:
• AT—Attention
• E0 (required)—No echo
• Q1—Result code on
• &D2—Normal data terminal ready (DTR) option
• &C1—Enable tracking the state of the data carrier
• S0=1—Pick up after one ring
• \015 (required)—Carriage return in octal
Use the modem set-string command to configure the user-input initialization string.
Examples This example shows how to download the default initialization string to the modem connected to the
console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# modem init-string default
default Downloads the default initialization string.
user-input Downloads the user-input initialization string.
Release Modification
4.0(0)N1(1a) This command was introduced.