Send comments to nx5000-docfeedback@cisco.com
8-23
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
clear rscn session
clear rscn session
To clear a Registered State Change Notification (RSCN) session for a specified VSAN, use the clear
rscn session command.
clear rscn session vsan vsan-id
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples The following example clears an RSCN session on VSAN 1:
switch# clear rscn session vsan 1
Related Commands
vsan vsan-id Specifies a VSAN where the RSCN session should be cleared. The ID of the
VSAN is from 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
rscn Configures an RSCN.
show rscn Displays RSCN information.
To Next Page
Loading...
