Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
5-11
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 5 Quality of Service Commands
match ip rtp
match ip rtp
To configure a class map to use the Real-Time Protocol (RTP) port as a match criteria, use the match ip
rtp command. To remove the RTP port as a match criteria, use the no form of this command.
match [not] ip rtp port-list
no match [not] ip rtp port-list
Syntax Description
Defaults None
Command Modes Class-map type qos configuration
Command History
Usage Guidelines To specify a list of values, use one of the following options:
• Specify a range of values separated by a dash
• Specify a noncontiguous list of values separated by commas
This command does not require a license.
Examples This example shows how to match on a port using RTP:
switch(config)# class-map my_test
switch(config-cmap-qos)# match ip rtp 2300
Related Commands
not (Optional) Negates the specified match result.
port-list Matches on the specified UDP or list of UDP ports that are using RTP.
Valid values range from 2000 to 65535.
Release Modification
4.1(3)N1(1) This command was introduced.
Command Description
show class-map Displays class maps.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English