Cisco AP775A - Nexus Converged Network Switch 5010 - Rscn

Send comments to nx5000-docfeedback@cisco.com
8-122
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
rscn
rscn
To configure a registered state change notification (RSCN), which is a Fibre Channel service that
informs N ports about changes in the fabric, use the rscn command.
rscn {multi-pid | suppress domain-swrscn} vsan vsan-id
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Examples The following example configures RSCNs in multi-PID format:
switch(config)# rscn multi-pid vsan 1
Related Commands
multi-pid Sends RSCNs in multiple port ID (multi-PID) format.
suppress
domain-swrscn
Suppresses transmission of domain format SW-RCSNs.
vsan vsan-id Configures VSAN information or membership. The ID of the VSAN is from
1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show rscn src-table Displays state change registration table,
show rscn statistics Displays RSCN statistics.