Cisco AP775A - Nexus Converged Network Switch 5010

Send comments to nx5000-docfeedback@cisco.com
8-33
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
device-alias rename
device-alias rename
To configure device names in the device alias database, use the device-alias rename command. To
remove device names from the device alias database, use the no form of the command.
device-alias rename device-name1 device-name2
no device-alias rename device-name
Syntax Description
Command Default None
Command Modes Device alias database configuration mode
Command History
Examples The following example shows how to configure a device name alias entry in the device name database:
switch(config)# device-alias database
switch(config-device-alias-db)# device-alias rename Device1 Device2
Related Commands
device-name1 Specifies the current device name.
device-name2 Specifies the new device name. Maximum length is 64 characters.
Release Modification
Release 4.0 This command was introduced.
Command Description
device-alias database Enters device alias database configuration mode.
show device-alias Displays device alias database information.