Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-145
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
zone clone
zone clone
To clone a zone name, use the zone clone command.
zone clone current-zone-name new-zone-name vsan vsan-id
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Usage Guidelines Use the no form of the zone name (configuration mode) command to delete the zone name.
Examples The following example creates a clone of the original zone group named origZone into the clone zone
group cloneZone on VSAN 45:
switch(config)# zone clone origZone cloneZone vsan 45
Related Commands
current-zone-name
new-zone-name
Clones a zone attribute group from the current name to a new name.
Maximum length of names is 64 characters.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show zone Displays zone information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English