Send comments to nx5000-docfeedback@cisco.com
2-52
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
spanning-tree cost
The EtherChannel bundle is considered a single port. The port cost is the aggregation of all the
configured port costs assigned to that channel.
Note Use this command to set the port cost for Rapid PVST+. Use the spanning-tree mst cost command to
set the port cost for MST.
Examples This example shows how to access an interface and set a path cost value of 250 for the spanning tree
VLAN that is associated with that interface:
switch(config)# interface ethernet 1/4
switch(config-if)# spanning-tree cost 250
Related Commands Command Description
show spanning-tree Displays information about the spanning tree configuration.
To Next Page
Loading...
