Send comments to nx5000-docfeedback@cisco.com
3-27
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show spanning-tree interface
Examples This example shows how to display STP information on a specified interface:
switch(config)# show spanning-tree interface ethernet 1/3
This example shows how to display detailed STP information on a specified interface:
switch(config)# show spanning-tree interface ethernet 1/3 detail
Related Commands Command Description
show spanning-tree Displays information about STP.
show spanning-tree
active
Displays information about STP active interfaces only.
show spanning-tree
bridge
Displays bridge ID, timers, and protocol for the local bridge on the switch.
show spanning-tree
brief
Displays brief summary information about STP.
show spanning-tree
detail
Displays detailed information about STP.
show spanning-tree
mst
Displays information about MST STP.
show spanning-tree
root
Displays status and configuration of the root bridge for the STP instance to
which this switch belongs.
show spanning-tree
summary
Displays summary information about STP.
show spanning-tree
vlan
Displays STP information for specified VLANs.
To Next Page
Loading...
