Send comments to nx5000-docfeedback@cisco.com
3-29
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show spanning-tree mst
This example shows how to display STP information about specified MST interfaces:
switch)# show spanning-tree mst interface ethernet 8/2
This example shows how to display information about the MST configuration:
switch)# show spanning-tree mst configuration
This example shows how to display the MD5 digest included in the current MST configuration:
switch)# show spanning-tree mst configuration digest
See Table 3-1 on page 3-19 for descriptions of the fields that are displayed in the output of show
spanning-tree commands.
Related Commands Command Description
show spanning-tree Displays information STP.
show spanning-tree
active
Displays information about STP active interfaces only.
show spanning-tree
bridge
Displays bridge ID, timers, and protocol for the local bridge on the switch.
show spanning-tree
brief
Displays brief summary information about STP.
show spanning-tree
detail
Displays detailed information about STP.
show spanning-tree
interface
Displays STP interface status and configuration of specified interfaces.
show spanning-tree
root
Displays status and configuration of the root bridge for the STP instance to
which this switch belongs.
show spanning-tree
summary
Displays summary information about STP.
show spanning-tree
vlan
Displays STP information for specified VLANs.
To Next Page
Loading...
