Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
6-83
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 6 Security Commands
radius-server host
Command Default Accounting port: 1813
Authentication port: 1812
Accounting: enabled
Authentication: enabled
Retransmission count: 1
Idle-time: 0
Server monitoring: disabled
Timeout: 5 seconds
Test username: test
Test password: test
Command Modes Configuration mode
Command History
Usage Guidelines When the idle time interval is 0 minutes, periodic RADIUS server monitoring is not performed.
Examples This example shows how to configure RADIUS server authentication and accounting parameters:
switch(config)# radius-server host 10.10.2.3 key HostKey
switch(config)# radius-server host 10.10.2.3 auth-port 2003
switch(config)# radius-server host 10.10.2.3 acct-port 2004
switch(config)# radius-server host 10.10.2.3 accounting
switch(config)# radius-server host radius2 key 0 abcd
switch(config)# radius-server host radius3 key 7 1234
switch(config)# radius-server host 10.10.2.3 test idle-time 10
switch(config)# radius-server host 10.10.2.3 test username tester
switch(config)# radius-server host 10.10.2.3 test password 2B9ka5
Related Commands
username name Specifies a username in the test packets. The maximum size is 32 characters.
timeout seconds Specifies the timeout (in seconds) between retransmissions to the RADIUS
server. The default is 1 second and the range is from 1 to 60 seconds.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show radius-server Displays RADIUS server information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English