Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
6-90
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 6 Security Commands
resequence
Examples This example shows how to resequence an IPv4 ACL named ip-acl-01 with a starting sequence number
of 100 and an increment of 10, using the show ip access-lists command to verify sequence numbering
before and after the use of the resequence command:
switch(config)# show ip access-lists ip-acl-01
IP access list ip-acl-01
7 permit tcp 128.0.0/16 any eq www
10 permit udp 128.0.0/16 any
13 permit icmp 128.0.0/16 any eq echo
17 deny igmp any any
switch(config)# resequence ip access-list ip-acl-01 100 10
switch(config)# show ip access-lists ip-acl-01
IP access list ip-acl-01
100 permit tcp 128.0.0/16 any eq www
110 permit udp 128.0.0/16 any
120 permit icmp 128.0.0/16 any eq echo
130 deny igmp any any
Related Commands Command Description
ip access-list Configures an IPv4 ACL.
mac access-list Configures a MAC ACL.
show access-lists Displays all ACLs or a specific ACL.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English