Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
10-10
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 10 Vpc Commands
show vpc consistency-parameters
• Enable/disable state the same per VLAN
• STP global settings
– Bridge Assurance setting
– Port type setting—We recommend that you set all vPC peer link ports as network ports.
– Loop Guard settings
• STP interface settings:
– Port type setting
– Loop Guard
– Root Guard
• Maximum transmission unit (MTU)
• Allowed VLAN bit set
This command is not available if you have not enabled the vPC feature. See feature vpc for information
on enabling vPCs.
This command does not require a license.
Examples This example shows how to display the vPC consistency parameters for the specified port channel:
switch (config)# show vpc consistency-parameters global
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name Type Local Value Peer Value
------------- ---- ------------------------ --------------------------
STP Mode 1 Rapid-PVST Rapid-PVST
STP Disabled 1 None None
STP MST 1 "" ""
Region Name
STP MST 1 0 0
Region
Revision
STP MST 1
Region
Instance to
VLAN Mapping
STP Loopguard 1 Disabled Disabled
STP Bridge 1 Enabled Enabled
Assurance
STP Port Type 1 Normal Normal
Allowed VLAN - 1-100 1-100
Local suspended - 1-50 -
VLANs
This example shows how to display the vPC consistency parameters for the specified port channel:
switch (config)# show vpc consistency-parameters interface port-channel 20
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name Type Local Value Peer Value
------------- ---- ------------------------ --------------------------
STP Port Type 1 Default Default

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English