D-Link DES-1210-52/ME - Delete Snmp V6 Host; Show Snmp V6 Host

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
90
identifies user name of an SNMP community. This string is used like
a password to give remote SNMP managers access to MIB objects
in the Switch’s SNMP agent.
noauth_nopriv − Specifies that there is no authorization and no
encryption of packets sent between the Switch and a remote SNMP
manager.
auth_nopriv − Specifies that authorization is required, but there is no
encryption of packets sent between the Switch and a remote SNMP
manager.
auth_priv − Specifies that authorization is required, and that packets
sent between the Switch and a remote SNMP manger are
encrypted.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To create an SNMP host to receive SNMP messages:
DES-1210-52/ME:5# create snmp v6host 3000::1 v3 noauth_nopriv dlink
Command: create snmp v6host 3000::1 v3 noauth_nopriv dlink
Success.
DES-1210-52/ME:5#
delete snmp v6host
Purpose
To remove a recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
delete snmp v6host <ip6_addr>
Description
The delete snmp host command deletes a recipient of SNMP traps
generated by the Switch’s SNMP agent.
Parameters
<ipv6_addr> − The IPv6 address of a remote SNMP manager that
receives SNMP traps generated by the Switch’s SNMP agent.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To delete an SNMP host entry:
DES-1210-52/ME:5# delete snmp v6host 3000::1
Command: delete snmp v6host 3000::1
Success.
DES-1210-52/ME:5#
show snmp v6host
Purpose
To display the recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
show snmp v6host {<ip6_addr>}
Description
The show snmp host command is used to display the IPv6
addresses and configuration information of remote SNMP managers