D-Link DES-1210-52/ME - Show 802.1 P User_Priority

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
198
1 0 0
2 0 0
3 1 0
4 2 1
5 2 1
6 3 2
7 3 2
Parameters
<priority 0-7> − The 802.1p priority value (0 to 7) to map to one of
the Switch’s four hardware priority classes of service.
<class_id 0-7> − The Switch’s hardware priority class of service (0
to 3) to map to the 802.1p priority value specified above.
Restrictions
Only administrator or operator level users can issue this command.
Example usage:
To configure 802.1 user priority on the Switch:
DES-1210-52/ME:5# config 802.1p user_priority 2 0
Command: config 802.1p user_priority 2 0
Success.
DES-1210-52/ME:5#
show 802.1p user_priority
Purpose
To display the current mapping between an incoming packet’s
802.1p priority value and one of the Switch’s eight hardware priority
classes of service.
Syntax
show 802.1p user_priority
Description
The show 802.1p user_priority command displays the current
mapping of an incoming packet’s 802.1p priority value to one of the
Switch’s four hardware priority queues.
Parameters
None.
Restrictions
None.
Example usage:
To show 802.1p user priority:
DES-1210-52/ME:5# show 802.1p user_priority
Command: show 802.1p user_priority
QOS Class of Traffic
Priority-0 -> <Class-2>
Priority-1 -> <Class-0>
Priority-2 -> <Class-1>
Priority-3 -> <Class-3>
Priority-4 -> <Class-4>
Priority-5 -> <Class-5>