D-Link DES-1210-52/ME - Enable Snmp DHCP_ Screening Traps; Disable Snmp DHCP_ Screening Traps; Enable Snmp Dhcpv6_ Screening Traps

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
101
Example usage:
To disable SNMP support on the Switch:
DES-1210-52/ME:5# disable snmp
Command: disable snmp
Success.
DES-1210-52/ME:5#
enable snmp DHCP_ screening traps
Purpose
To enable SNMP DHCP screening traps.
Syntax
enable snmp DHCP_screening traps
Description
The enable snmp DHCP_screening traps command enables
SNMP DHCP screening traps support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP DHCP screening traps support on the Switch:
DES-1210-52/ME:5# enable snmp DHCP_screening traps
Command: enable snmp DHCP_screening traps
Success.
DES-1210-52/ME:5#
disable snmp DHCP_ screening traps
Purpose
To disable SNMP DHCP screening traps.
Syntax
disable snmp DHCP_screening traps
Description
The disable snmp DHCP_screening traps command enables
SNMP DHCP screening traps support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP DHCP screening traps support on the Switch:
DES-1210-52/ME:5# disable snmp DHCP_screening traps
Command: disable snmp DHCP_screening traps
Success.
DES-1210-52/ME:5#
enable snmp DHCPv6_ screening traps
Purpose
To enable SNMP DHCPv6 screening traps.