D-Link DES-1210-52/ME - Dhcp Relay Commands

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
114
16
DHCP RELAY COMMANDS
The DHCP Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable dhcp_relay
disable dhcp_relay
config dhcp_relay port
<portlist> state [enable | disable]
config dhcp_relay add
ipif System
<ipaddr>
config dhcp_relay
delete ipif System
<ipaddr>
config dhcp_relay hops
<value 1-16>
config dhcp_relay vlan
[<vlan_name 32> | vlanid <vidlist>] state [enable | disable]
config dhcp_relay
option_82
[check [enable | disable] | policy [drop | keep | replace] | remote_id [default |
user_define <desc 32>] | state [enable | disable] | circuit_id [default | user_define
<desc 32>] ]
config dhcp_relay
port_option_82
{<portlist>} [ circuit_id | remote_id ] vendor3 <desc 32>
show dhcp_relay
port_option_82
{<portlist>}
show dhcp_relay
{ipif}
enable
dhcp_local_relay
disable
dhcp_local_relay
config dhcp_local_relay
port
port <portlist> state [enable | disable]
config dhcp_local_relay
vlan
[<vlan_name 32> | vlanid <vidlist>] state [enable | disable]
show dhcp_local_relay
enable dhcpv6_relay
disable dhcpv6_relay
show dhcpv6_relay
{ipif System | option_38 ports <portlist>}
config dhcpv6_relay
[add | delete] ipif system <ip6_addr>
config dhcpv6_relay
hop_count
<value 1-32>
config dhcpv6_relay
option_37
[check | state] [enable | disable] | remote_id [default | user_define <string 128> |
cid_with_user_define <string 128>]]