D-Link DES-1210-52/ME - Show Stp Ports; Show Stp Instance

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
159
show stp ports
Purpose
To display the Switch’s current instance_id configuration.
Syntax
show stp ports {<portlist>}
Description
The show stp ports command displays the STP Instance Settings
and STP Instance Operational Status currently implemented on the
Switch.
Parameters
<portlist> – A port or range of ports to be configured. The port list is
specified by listing switch number and the beginning port number on
that switch, separated by a colon. Then the highest port number of
the range is specified. The beginning and end of the port list range
are separated by a dash.
Restrictions
None.
Example usage:
To show stp port 1 on switch one:
DES-1210-52/ME:5# show stp ports 1
Command: show stp ports 1
MSTP Port Information
------------------------------
Port Index:1 , Port STP:Enabled , P2P:Auto ,
External PathCost : AUTO/200000 , Edge Port:Auto ,
Port RestrictedRole:False , Port RestrictedTCN:False
Port Priority:128 , Port Forward BPDU:Enabled ,
MSTI Designated Bridge Internal PathCost Prio Status Role
------ ---------------------------- ------------------------- ------ ---------- ----------
0 80:00:00:01:02:03:04:05 200000 128 Disabled Disabled
DES-1210-52/ME:5#
show stp instance
Purpose
To display the Switch’s STP instance configuration
Syntax
show stp instance {<value 0-63>}
Description
The show stp instance command displays the Switch’s current
STP Instance Settings and the STP Instance Operational Status.
Parameters
<value 0-63> - The value of the previously configured instance_id on
the Switch. The value may be between 0 and 63. An entry of 0
displays the STP configuration for the CIST internally set on the
Switch.
Restrictions
None.
Example usage:
To display the STP instance configuration for instance 0 (the internal CIST) on the Switch:
DES-1210-52/ME:5# show stp instance 0
Command: show stp instance 0