D-Link DES-1210-52/ME - Config Snmp Linkchange_Traps Ports; Show Snmp Traps Linkchange_Traps

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
97
Example usage:
To disable the SNMP link change trap function:
DGS-1210-28P/ME:5# disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-1210-28P/ME:5#
config snmp linkchange_traps ports
Purpose
To configure SNMP traps support on the Switch.
Syntax
config snmp linkchange_traps ports [<portlist> | all] [enable |
disable]
Description
The config snmp linkchange_traps ports command configures
the SNMP trap support status currently configured on the Switch.
Parameters
[<portlist> | all] – Specifies a port, ports or port range to be
configured.
[enable | disable] – Enable or disable the SNMP trap support for
specified port.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the current SNMP trap settings:
DES-1210-52/ME:5# config snmp linkchange_traps ports 8-10 enable
Command: config snmp linkchange_traps ports 8-10 enable
Success.
DES-1210-52/ME:5#
show snmp traps linkchange_traps
Purpose
To show SNMP traps support on the Switch.
Syntax
show snmp traps linkchange_traps
Description
The show snmp traps command displays the SNMP trap support
status currently configured on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To view the current SNMP trap support:
DES-1210-52/ME:5# show snmp traps linkchange_traps
Command: show snmp traps linkchange_traps
Linkchange Traps : Disable
Port 01: Disabled