D-Link DES-1210-52/ME - Config Radius Delete; Config Radius

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
308
Success.
DES-1210-52/ME:5#
config radius delete
Purpose
To delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1-3>
Description
The config radius delete command deletes a previously entered
RADIUS server configuration.
Parameters
<server_index 1-3> – The index of the RADIUS server.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
DES-1210-52/ME:5# config radius delete 1
Command: config radius delete 1
Success.
DES-1210-52/ME:5# #
config radius
Purpose
To configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> { key <passwd 32> | auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-
65535> | ipaddress [<ipaddr> | <ipv6_addr>] | retransmit <int 1-
255> | timeout <int 1-255>}
Description
The config radius command configures the Switch’s RADIUS
settings.
Parameters
<server_index 1-3> – The index of the RADIUS server.
key – Specifies that a password and encryption key are to be used
between the Switch and the RADIUS server.
 <passwd 32> – The shared-secret key used by the
RADIUS server and the Switch. Up to 32 characters can
be used.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
ipaddress [<ipaddr> | <ipv6_addr>] – The IPv4 or IPv6 address of
the RADIUS server.
retransmit <int 1-255> – The number of times the device resends an
authentication request when the server does not respond. The value
is between 1 and 255.
timeout <int 1-255> – Specifies the connection timeout. The value
may be between 1 and 255 seconds.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage: