D-Link DES-1210-52/ME - Ethernet Oam Commands; Config Ethernet_Oam Ports

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
246
33
ETHERNET OAM COMMANDS
The Ethernet OAM commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config ethernet_oam
ports
[<portlist> | all] mode [active | passive] {received_remote_loopback [ignore |
process] | remote_loopback [start | stop] | state [enable | disable]}
config ethernet_oam
ports
[<portlist> | all] critical_link_event [critical_event | dying_gasp] notify_state
[enable | disable]
config ethernet_oam
ports
[<portlist> | all] link_monitor [error_frame | error_frame_period |
error_frame_seconds | error_symbol] notify_state [enable | disable] {threshold
<integer 1-4294967295> | window <integer 1000-60000>}
show ethernet_oam
ports
[<portlist> | all] status
show ethernet_oam
ports
[<portlist> | all] configuration
show ethernet_oam
ports
[<portlist> | all] statistics
show ethernet_oam
ports
[<portlist> | all] event_log {index <value_list>}
clear ethernet_oam
ports
[<portlist> | all] [event_log | statistics]
Each command is listed in detail, as follows:
config ethernet_oam ports
Purpose
Used to configure Ethernet OAM mode.
Syntax
config ethernet_oam ports [<portlist> | all] mode [active |
passive] {received_remote_loopback [ignore | process] |
remote_loopback [start | stop] | state [enable | disable]}
Description
The config ethernet_oam ports command is used to configure
ports Ethernet OAM to operate in active or passive mode. The
following two actions are allowed by ports in active mode, but
disallowed by ports in passive mode.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
mode – Specifies to operate in either active mode or passive mode.
The default mode is active.
received_remote_loopback [ignore | process] – Specifies the
received remote loopback to be ignore or process.
remote_loopback [start | stop] – Specifies the remote loopback to be
started or stopped.