D-Link DES-1210-52/ME - Config Igmp Access_Authentication Ports; Show Igmp Access_Authentication Ports

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
267
all − Specifies all ports on the Switch to be configured.
[add | delete] – Specifies whether to deny ports defined in the
following parameter <portlist>, to the router port function.
<portlist> − A port or range of ports that will be denied access as
router ports.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To deny router ports:
DES-1210-52/ME:5# config router_ports_forbidden vlanid 2 add 10-12
Command: config router_ports_forbidden vlanid 2 add 10-12
Success.
DES-1210-52/ME:5#
config igmp access_authentication ports
Purpose
To configure the IGMP access authentication on the Switch.
Syntax
config igmp access_authentication ports [<portlist> | all] state
[enable | disable]
Description
The config igmp access_authentication ports command
configures the IGMP access authentication on the Switch.
Parameters
<portlist> − A port or range of ports that will be configured as IGMP
access authentication ports.
all − Specify all ports to be configured as IGMP access
authentication ports.
State [enable | disable] − Specifies the state for the port to be
disabled or enabled.
Restrictions
Only administrator, operator or power user-level users can issue this
command.
Example usage:
To configure authentication port of IGMP:
DES-1210-52/ME:5# config igmp access_authentication ports all state enable
Command: config igmp access_authentication ports all state enable
Success.
DES-1210-52/ME:5#
show igmp access_authentication ports
Purpose
To display the IGMP access authentication configuration on the
Switch.
Syntax
show igmp access_authentication ports [<portlist> | all]
Description
The show igmp access_authentication command displays the
IGMP access authentication configuration on the Switch.
Parameters
all − Specifies all ports to be displayed.