D-Link DES-1210-52/ME - Static Mac_Based Vlan Commands; Create Mac_Based_Vlan Mac_Address

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
333
45
STATIC MAC_BASED VLAN COMMANDS
The Static MAC_based VLAN commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
create mac_based_vlan
mac_address
<macaddr> [vlan <vlan_name 32> | vlanid <vlanid 1-4094>]
delete mac_based_vlan
{mac_address <macaddr> [vlan <vlan_name 32>| vlanid <vlanid 1-4094>]}
show mac_based_vlan
mac_address
{mac_address <macaddr> [vlan <vlan_name 32>| vlanid <vlanid 1-4094>]}
Each command is listed in detail, as follows:
create mac_based_vlan mac_address
Purpose
To create static MAC-based VLAN entries.
Syntax
create mac_based_vlan mac_address <macaddr> [vlan
<vlan_name 32> | vlanid <vlanid 1-4094>]
Description
The create mac_based_vlan mac_address command is used to
create static MAC-based VLAN entries.
Parameters
<macaddr> - Specify the MAC address to be created.
<vlan_name 32> - Specify the VLAN name. The maximum length is
32 characters
<vlanid 1-4094> - Specify the VLAN ID between 1 and 4094.
Restrictions
Only Administrator and operator-level users can issue this
command.
Example usage:
To create a static MAC-based VLAN entry:
DES-1210-52/ME:5# create mac_based_vlan mac_address 00-00-00-00-00-01
vlan default
Command: create mac_based_vlan mac_address 00-00-00-00-00-01 vlan
default
Success.
DES-1210-52/ME:5#