D-Link DES-1210-52/ME - Show Gratuitous_Arp; Config Gratuitous_Arp Send Periodically

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
135
DES-1210-52/ME:5#
show gratuitous_arp
Purpose
Used to display the gratuitous ARP configuration.
Syntax
show gratuitous_arp
Description
The show gratuitous_arp command is used to display the
gratuitous ARP configuration.
Parameters
None.
Restrictions
None.
Example usage:
To display gratuitous ARP log and trap states:
DES-1210-52/ME:5# show gratuitous_arp
Command: show gratuitous_arp
Send on IPIF status up : Enabled
Send on Duplicate_IP_Detected : Enabled
Gratuitous ARP Learning : Enabled
IP Interface Name : System
Gratuitous ARP Trap : Enabled
Gratuitous ARP Log : Disabled
Gratuitous ARP Periodical Send Interval : 0
DES-1210-52/ME:5#
config gratuitous_arp send periodically
Purpose
Used to configure the interval for periodical sending of gratuitous
ARP request packets.
Syntax
config gratuitous_arp send periodically ipif <ipif_name 12>
interval <integer 0-65535>
Description
The config gratuitous_arp send periodically ipif command is
used to configure the interval for periodical sending of gratuitous
ARP request packets. By default, the interval is 0.
Parameters
ipif <ipif_name 12> - Specifies the IP interface name to be
configured.
interval <integer 0-65535> − Periodically send gratuitous ARP
interval time in seconds. 0 means it will not send gratuitous ARP
periodically.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure gratuitous ARP intervals for the Switch:
DES-1210-52/ME:5# config gratuitous_arp send periodically ipif rrd2 interval 100