D-Link DES-1210-52/ME - Config Stp Trap

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
164
config stp trap
Purpose
To configure the sending state for STP traps.
Syntax
config stp trap {new_root [enable | disable] | topo_change
[enable | disable]}
Description
The config stp mst_ports command is used to configure the
sending state for STP traps.
Parameters
new_root [enable | disable] – Enable or disable sending of new root
trap. The default state is enabled.
topo_change [enable | disable] – Enable or disable sending of
topology change trap. The default state is enabled.
Restrictions
Only Administrator level users can issue this command.
Example usage:
To configure the new root and topo change to be enabled for STP trap:
DES-1210-52/ME:5# config stp trap new_root disable topo_change enable
Command: config stp trap new_root disable topo_change enable
Success.
DES-1210-52/ME:5#