D-Link DES-1210-52/ME - Show 802.1 X Fwd_Pdu System Status; Config 802.1 X Auth_Mode

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
310
command.
Example usage:
To enable 802.1x forwarding EAPOL PDU
DES-1210-52/ME:5# config 802.1x fwd_pdu system enable
Command: config 802.1x fwd_pdu system enable
Success.
DES-1210-52/ME:5#
show 802.1x fwd_pdu system status
Purpose
To display the 802.1x forwarding EAPOL PDU status on the Switch.
Syntax
show 802.1x fwd_pdu system status
Description
The show 802.1x fwd_pdu system status command is used to
display the control of forwarding EAPOL PDUs.
Parameters
None.
Restrictions
None.
Example usage:
To show 802.1x forwarding EAPOL PDU status:
DES-1210-52/ME:5# show 802.1x fwd_pdu system status
Command: show 802.1x fwd_pdu system status
PNAC control packet (eap) is forwarding....
Success.
DES-1210-52/ME:5#
config 802.1x auth_mode
Purpose
To configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode [port_based | mac_based]
Description
The config 802.1x auth_mode command enables either the port-
based or MAC-based 802.1x authentication feature on the Switch.
Parameters
[port_based | mac_based] – Specifies whether 802.1x
authentication is by port or MAC address.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To configure 802.1x authentication by port address: