DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
382
Each command is listed in detail, as follows:
To enable LLDP on the switch.
The enable lldp command enables the Link Layer Discovery
Protocol (LLDP) on the switch.
Only Administrator or operator–level users can issue this command.
Example usage:
To enable LLDP on the switch:
DES-1210-52/ME:5# enable lldp
Command: enable lldp
Success.
DES-1210-52/ME:5#
To disable LLDP on the switch.
The disable lldp command disables the Link Discovery Protocol
(LLDP) on the switch.
Only Administrator or operator–level users can issue this command.
Example usage:
To disable LLDP on the switch:
DES-1210-52/ME:5# disable lldp
Command: disable lldp
Success.
DES-1210-52/ME:5#
config lldp message_tx_interval
To define the lldp message tx interval
config lldp message_tx_interval <sec 5-32768>
The config lldp message_tx_interval defines the lldp message
interval of the incoming messages.
<sec 5-32768> – Defines the message interval time. The range is
between 5 and 32768.
Only Administrator or operator–level users can issue this command.
Example usage:
To configure LLDP message tx interval on the switch:
To Next Page
Loading...
