D-Link DES-1210-52/ME - Config Igmp_Snooping Data_Driven_Learning; Clear Igmp_Snooping Data_Driven_Group

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
265
Success.DES-1210-52/ME:5#
config igmp_snooping data_driven_learning
Purpose
Used to configure the data driven learning of an IGMP snooping
group.
Syntax
config igmp_snooping data_driven_learning
max_learned_entry <integer 1-512>
Description
The config igmp_snooping data_driven_learning command
configures the max learned entry of IGMP snooping data driven
learning on the Switch.
Parameters
max_learned_entry <integer 1-512> − Specify the max learned
entry, the range is from 1 to 256.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure the igmp snooping data driven learning on the Switch:
DES-1210-52/ME:5# config igmp_snooping data_driven_learning
max_learned_entry 10
Command: config igmp_snooping data_driven_learning max_learned_entry 10
Success.
DES-1210-52/ME:5#
clear igmp_snooping data_driven_group
Purpose
To clear the IGMP snooping group learned by data drive.
Syntax
clear igmp_snooping data_driven_group [all | vlan_name
<vlan_name 32> | vlanid <vidlist>] [all | MCGroupAddr <ipaddr>]
Description
The config igmp_snooping data_driven_learning command is
used to delete the IGMP snooping group learned by data drive.
Note that this commands is currently only for layer 2 switches.
Parameters
all − Delete all data driven entries.
vlan_name <vlan_name 32> − The name of the VLAN for which
IGMP snooping is to be configured. Up to 20 characters can be
used.
vlanid <vidlist> − Specify the vlan id of the IGMP snooping data
driven group on the Switch.
<ipaddr> - Specifies the IP address.
Restrictions
Only administrator, operator or power user-level users can issue this
command.
Example usage:
To clear the igmp snooping data driven group on the Switch:
DES-1210-52/ME:5# clear igmp_snooping data_driven_group all