D-Link DES-1210-52/ME - Config Snmp Coldstart_Traps; Enable Snmp; Disable Snmp

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
100
Success.
DES-1210-52/ME:5#
config snmp coldstart_traps
Purpose
To enable or disable the cold start traps of SNMPon the Switch.
Syntax
config snmp coldstart_traps [enable | disable]
Description
The config snmp coldstart_traps command enable or disable the
cold start traps of the Switch.
Parameters
[enable | disable] – Enable or disable the cold start traps of the
Switch.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP cold start traps for the Switch:
DES-1210-52/ME:5# config snmp coldstart_traps disable
Command: config snmp coldstart_traps disable
Success.
DES-1210-52/ME:5#
enable snmp
Purpose
To enable SNMP support.
Syntax
enable snmp
Description
The enable snmp command enables SNMP support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP support on the Switch:
DES-1210-52/ME:5# enable snmp
Command: enable snmp
Success.
DES-1210-52/ME:5#
disable snmp
Purpose
To disable SNMP support.
Syntax
disable snmp
Description
The disable snmp command enables SNMP support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.