DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
243
Used to configure trap and log settings for BPDU attack protection
events.
config bpdu_protection [ trap | log ] [ none | attack_detected |
attack_cleared | both ]
The config bpdu_protection command to configure the trap and
log state for BPDU attack protection and specify the type of event
sent or logged.
trap – Specifies the trap state. The default state is both trap and log.
log – Specifies the log state. The default state is both trap and log.
none – Specifies that events will not be logged or trapped for both
cases.
attack_detected – Specifies that events will be logged or trapped
when a BPDU attack is detected.
attack_cleared – Specifies that events will be logged or trapped
when the BPDU attack is cleared.
both – Specifies that events will be logged or trapped for both cases.
The default setting for log is both and for trap is none.
Only administrator-level users can issue this command
Example usage:
To configure the BPDU Attack Protection recovery timer to 120 second for the entire switch:
DES-1210-52/ME:5# config bpdu_protection trap both
Command: config bpdu_protection trap both
Success.
DES-1210-52/ME:5#
Used to globally enable BPDU attack protection on the Switch.
The enable bpdu_protection command is used to globally enable
BPDU attack protection on the Switch.
The BPDU Attack Protection function and Spanning Tree Protocol
for ports are mutually exclusive. When the STP function is enabled
on a particular port, BPDU Attack Protection cannot be enabled.
Only administrator-level users can issue this command.
Example usage:
To enable BPDU attack protection on the entire Switch:
To Next Page
Loading...
