D-Link DES-1210-52/ME - Config Mld_Snooping Data_Driven_Learning

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
285
for expected packet loss on a subnet. The user may choose a value
between 1 and 255 with a default setting of 2. If a subnet is expected
to be lossy, the user may wish to increase this interval.
state [enable | disable] – Enabling the querier state will set the
Switch as a MLD querier and disabling it will set it as a Non-querier.
The default setting is disabled.
version <value 1-2> – Specify the version of MLD packet that will be
sent by this port. If a MLD packet received by the interface has a
version higher than the specified version, this packet will be forward
from router ports or VLAN flooding. The value is between 1 and 2.
Restrictions
Only administrator, operator or power user–level users can issue
this command.
Example usage:
To configure MLD snooping querier:
DES-1210-52/ME:5#config mld_snooping querier all last_listener_query_interval
1 max_response_time 10 query_interval 60 robustness_variable 2 state disable
version 1
Command: config mld_snooping querier all last_listener_query_interval 1
max_response_time 10 query_interval 60 robustness_variable 2 state disable
version 1
Success.
DES-1210-52/ME:5#
config mld_snooping data_driven_learning
Purpose
To enable or disable the data-driven learning of an MLD snooping
group on the Switch.
Syntax
config mld_snooping data_driven_learning [max_learned_entry
<value 1-512>| vlan_name <string 32> | vlanid <vidlist> | all]
[age_out [disable | enable] | expiry_time <sec 130-1530255> |
state [enable | disable]]
Description
The config mld_snooping data driven_learning command used to
enable or disable the data-driven learning of an MLD snooping
group.
Parameters
max_learned_entry <value 1-512> – Specifies the maximum learned
entry value.
vlan_name <string 32> – Specifies that the mld snooping applies
only to this previously created VLAN.
vlanid <vidlist> – Specifies that the mld snooping applies only to this
previously created VLAN id.
all – Specifies that MLD snooping is to be configured for all VLANs
on the Switch.
age_out [disable | disable] –Enable or disable the aging out of
entries. By default, the state is disabled.
expiry_time <sec 130-1530255> –Specify the data driven group
lifetime, in seconds. The value is between 130 and 1530255.
state [enable | disable] –Specify to enable or disable the data driven
learning of MLD snooping groups.
Restrictions
Only administrator–level users can issue this command.