D-Link DES-1210-52/ME - Config Configuration Config_Id; Show Firmware Information

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
110
must be on the same IP subnet as the Switch.
<ipv6_addr> − The IPv6 address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
<path_filename 64> − The location of the Switch configuration file on
the TFTP server.
image_id <value 1-2> - Specifies the image id which to be uploaded.
config_id <value 1-2> − Specifies the config id which to be
uploaded.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
DES-1210-52/ME:5# upload log_toTFTP 172.21.45.73 log1
Command: upload log_toTFTP 172.21.45.73 log1
Success.
DES-1210-52/ME:5#
config configuration config_id
Purpose
Used to delete the specific firmware or configure the specific
firmware as boot up image.
Syntax
config configuration config_id <value 1-2> [boot_up | delete]
Description
The config configuration config_id command is used to delete the
specific firmware or configure the specific firmware as boot up
image.
Parameters
<value 1-2> − Specifies the serial number of the indicated
configuration.
[boot_up | delete] − Specifies the config is boot_up config or delete
the specified configuration.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
DES-1210-52/ME:5# config configuration config_id 1 boot_up
Command: config configuration config_id 1 boot_up
Success.
DES-1210-52/ME:5#
show firmware information
Purpose
Used to display the firmware section information.
Syntax
show firmware information
Description
The show firmware information command is used to display the
firmware section information.
Parameters
None.
Restrictions
None.
Example usage: