DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
244
DES-1210-52/ME:5# enable bpdu_protection
Command: enable bpdu_protection
Success.
DES-1210-52/ME:5#
Used to globally disable BPDU attack protection on the Switch.
The disable bpdu_protection command is Use this to disable
BPDU attack protection on the entire Switch. Note that if BPDU
attack protection is disabled globally, it will also be disabled for ports
regardless of the config bpdu_protection ports settings.
Only administrator-level users can issue this command.
Example usage:
To disable BPDU attack protection on the entire Switch:
DES-1210-52/ME:5# disable bpdu_protection
Command: disable bpdu_protection
Success.
DES-1210-52/ME:5#
Used to display BPDU attack protection settings on the Switch.
show bp
du_protection {ports <portlist>}
The show bpdu_protection command is used to view the global or
per port BPDU attack protection configuration.
ports – Specify to view the BPDU attack protection port
configuration.
<portlist> – Specify the ports to display. If none is specified, all ports
BPDU attack protection configuration will be listed.
Example usage:
To display global settings for BPDU protection:
To Next Page
Loading...
